Closeout/Insulator Panel Replacement - Right

Closeout/Insulator Panel Replacement - Right

Removal Procedure




1. Remove the 2 screws that retain the insulator panel to the instrument panel (IP).
2. Partially remove the insulator panel.
3. Remove the electrical connector retaining clip from the back side of the insulator panel if equipped.
4. Remove the insulator panel from the vehicle.

Installation Procedure




1. Install the insulator panel to the vehicle, positioning the insulator panel to the IP.
2. Install the electrical connector retaining clip to the back side of the insulator panel if equipped.
3. Insert the insulator panel retaining tab into the cowl slot.
4. Seat the insulator panel retaining clip to the IP substrate.

Notice: Refer to Fastener Notice in Service Precautions.

5. Install the 2 insulator panel retaining screws.

Tighten the screws to 2.5 N.m (22 lb in).