Operation CHARM: Car repair manuals for everyone.

Spark Plug: Service and Repair



SPARK PLUG REPLACEMENT

Removal Procedure






1. Remove the spark plug wire. Service and Repair

2. Remove the washer solvent container to gain access to the # 2 spark plug. Service and Repair

3. Loosen the spark plug 1 or 2 turns.

4. Brush or using compressed air, blow away any dirt from around the spark plug.

5. Remove the spark plug. If removing more than one plug, place each plug in a tray marked with the corresponding cylinder number.

Installation Procedure






1. Inspect the spark plug gap. Adjust the gap as needed.

Specification
Spark plug gap: 1.524 mm (0.060 in)

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Hand start the spark plug in the corresponding cylinder.

3. Tighten the spark plug.

Tighten
- Tighten the plug to 15 Nm (11 lb ft) for used heads.
- Tighten the plug to 20 Nm (15 lb ft) for NEW heads.

4. Install the spark plug wire. Service and Repair

5. Install the washer solvent container. Service and Repair