Reverse Servo Replacement

Reverse Servo Replacement

Removal Procedure





1. Remove the transmission filter.
2. Remove the rear servo from the transmission case in the following order:
2.1. Cover bolts (6)
2.2. Cover (5)
2.3. Cover gasket (4)
2.4. Bottom retaining clip (3)
2.5. Servo piston (2)
2.6. Outer ring oil seal (1)
2.7. Inner ring oil seal (7)
2.8. Accumulator piston (8)
2.9. Piston seal (9)
2.10. Washer (10)
2.11. Servo spring (11)
2.12. Servo spring retainer (12)
2.13. Selective pin (13)
2.14. Accumulator spring (14)

Installation Procedure





1. Install the rear servo to the transmission in the following order:
1.1. Accumulator spring (14)
1.2. Selective pin (13)
1.3. Servo spring retainer (12)
1.4. Servo spring (11)
1.5. Washer (10)
1.6. Piston seal (9)
1.7. Accumulator piston (8)
1.8. Inner ring oil seal (7)
1.9. Outer ring oil seal (1)
1.10. Servo piston (2)
1.11. Bottom retaining clip (3)
1.12. Cover gasket (4)
1.13. Cover (5)
1.14. Cover bolts (6)

Notice: Refer to Fastener Notice in Service Precautions.

2. Tighten the cover bolts (61).
^ Tighten the bolts to 24 Nm (18 ft. lbs.).
3. Install the transmission filter.