Transfer Case Adapter Replacement

Transfer Case Adapter Replacement

Removal Procedure
1. Remove the transfer case.





2. Remove the transfer case adapter bolts.
3. Remove the adapter.
4. Remove the adapter seal.

Installation Procedure

Important: Always use a new seal for the adapter. Do not use any type of sealant or adhesive in place of, or with the seal.





1. Install a NEW seal onto the adapter.

Important: The transfer case adapter must be installed so that the adapter is evenly seated to the transmission before installing the retaining nuts.

2. Install the adapter.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the adapter bolts.
Tighten the bolts to 50 Nm (37 ft. lbs.).
4. Install the transfer case.