Evaporative Emission Control Canister: Service and Repair
Evaporative Emission (EVAP) Canister ReplacementREMOVAL PROCEDURE
IMPORTANT: Clean all EVAP pipe connections and surrounding areas before disconnecting the pipes in order to avoid possible contamination of the EVAP system.
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the evaporative emission (EVAP) canister vent pipe (5) from the canister.
3. Remove the vent pipe clip (4) from the canister bracket.
4. Disconnect the EVAP pipe from the canister.
5. Disconnect the fuel tank vapor pipe (3) from the canister.
6. Cap the EVAP pipes in order to prevent possible EVAP system contamination.
7. Remove the EVAP canister bolts.
8. Remove the EVAP canister.
INSTALLATION PROCEDURE
1. Install the EVAP canister.
NOTE: Refer to Fastener Notice in Service Precautions Fastener Notice.
2. Install the EVAP canister bolts.
Tighten
Tighten the bolts to ....................................25 N.m (18 lb ft).
3. Remove the caps from the EVAP pipes.
4. Connect the fuel tank vapor pipe (3) to the canister.
5. Connect the EVAP pipe to the canister.
6. Install the vent pipe clip (4) to the canister bracket.
7. Connect the EVAP canister vent pipe (5) to the canister.
8. Lower the vehicle.