Inst. Panel, Elec. Center, or Junction Block Replacement-Right

REMOVAL PROCEDURE
1. Remove the right side end panel.
2. Push in the tabs in order to remove the fuse block.




3. Pull out the fuse block out of the I/P in order to remove the retaining bolt.
4. Loosen the bolt.
5. Insert a screw driver between the wire harness block and fuse block in order to separate.
6. Separate the fuse block from the I/P harness block.
7. Remove the I/P wiring harness block from the vehicle.

INSTALLATION PROCEDURE
1. Install the fuse block to the I/P wire harness block.
2. Install the retaining bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the bolt to 6 N.m (53 lb in)




3. Install the fuse block to the I/P until it clicks in place.




4. Connect the wiring connectors to the fuse block.
5. Install the right side end panel.