112. Rear Cover Selective Spacer Measurement

Rear Cover Selective Spacer Measurement - 4WD





1. Position the main housing so that the rear of the main housing is facing up.
2. At dimension A, measure the distance from the rear face of rear cover (1) to the rear face of bearing spacer (2).
3. At dimension B measure the distance from the rear face of rear cover module (3) to the rear face of retaining ring (4).
4. Calculate Dimension C by subtracting Dimension B from Dimension A.





5. Select the appropriate selective spacer (1) based upon Dimension C. Refer to Selective Components Specifications.
6. Install selective spacer (1) onto output shaft (2).