Wipers Inoperative - One or More Modes
WIPERS INOPERATIVE - ONE OR MORE MODESTEST DESCRIPTION
Steps 1 - 3:
Steps 4 - 5:
Steps 6 - 10:
Steps 11 - 15:
The numbers below refer to the step numbers on the diagnostic table.
5. This step tests for continuity through the 390 Ohm resistor in the windshield wiper/washer switch.
6. This step tests for continuity through the delay resistors in the windshield wiper/washer switch. The measured resistance will change in sequence from low to high as the delay speed is increased.