76. Valve Rocker Arm and Push Rod Installation

Valve Rocker Arm and Push Rod Installation





Important: Keep the parts in order. Parts must be put back from where they were removed.

1. Apply sealer GM P/N 12346004, (Canadian P/N 10953480), or equivalent to the valve rocker arm stud-to-cylinder head threads.

Notice: Refer to Fastener Notice in Service and Precautions.
Fastener Notice


2. Install the push rod guides and valve rocker arm studs onto the cylinder head.
Tighten the valve rocker arm studs to 50 Nm (37 lb ft).

Important: The 8.1L engine uses different length intake and exhaust valve push rods.

The exhaust valve push rods (2) are longer than the intake valve push rods (1).





3. Install the valve push rods.





4. Coat the valve rocker arm and valve rocker arm ball bearing surfaces with prelube GM P/N 1052367, (Canadian PIN 992869), or equivalent.
5. Install the valve rocker arms, the valve rocker arm balls and the valve rocker arm nuts.
Tighten the valve rocker arm nuts slowly to 35 Nm (26 lb ft), while guiding the tips of the rocker arms over the tips of the valves.