Operation CHARM: Car repair manuals for everyone.

Ignition Switch



IGNITION SWITCH REPLACEMENT

TOOLS REQUIRED
J 42759 Ignition Switch Connector Release Tool

REMOVAL PROCEDURE




1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.

CAUTION: Refer to SIR Caution in Service Precautions.

2. Remove the upper and lower trim covers.
3. Remove the wire harness strap (2) from the steering column and the wire harness assembly (1).

IMPORTANT: The abrasion sleeve located on the steering column wire harness assembly must be reinstalled. Make note of what connector is coming out of the abrasion sleeve for installation purposes.




4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).




5. Rotate the key alarm connector (1) 90 degrees.
6. Pull the key alarm connector (1) out of the ignition lock cylinder case (2).
7. Remove the passkey connector from the ignition lock cylinder case (2).




8. Insert J 42759 into the ignition lock cylinder case (1) and slide the ignition switch (2) out.

INSTALLATION PROCEDURE




1. Install the ignition lock cylinder case (1) and slide the ignition switch (2) in.

IMPORTANT: Before installing a new ignition switch, the lock cylinder gear has to be rotated counterclockwise until it hits the stop. Counterclockwise from the drivers perspective. In order to rotate the lock cylinder all the way the key and lock cylinder need to be removed. Once the key and lock cylinder are removed, rotate counterclockwise with a screw driver.




2. Push the key alarm connector (1) into the ignition lock cylinder case (2).
3. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
4. Install the passkey connector into the ignition lock cylinder case (2).




5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).




6. Attach the wire harness strap (2) to the wire harness assembly (1) and the steering column.

IMPORTANT: The abrasion sleeve must be installed back onto the steering column wire harness assembly. The ignition lock cylinder case wires and connector must be hanging out of the middle of the abrasion sleeve.

7. Install the upper and lower trim covers.
8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.