Sunroof Seal/Molding Replacement RPO Code Zrx/Extreme W/CF5

SUNROOF SEAL/MOLDING REPLACEMENT WITH RPO CODE ZRX/EXTREME W/ CF5

REMOVAL PROCEDURE




1. Remove the sunroof window.
2. Remove the seal (2) from the front of the upper frame by pulling upward on the seal.
3. Finish removing the seal from the rear of the mainframe.
4. Completely clean the channel in the mainframe of silicone adhesive and any other debris. A nylon glazing stick or a soft wire brush would be helpful in removing the silicone.

INSTALLATION PROCEDURE




1. Apply black, non-corrosive silicone adhesive under the entire outside edge of the seal.
2. Insert the new window seal by pressing the seal into the mainframe channel (3). Use a roller-type tool on the seal to aid in the installation of the seal into the channel.
3. Install the sunroof window.
4. Fully close the sunroof and wait 4-6 hours for the silicone to dry.
5. Visually inspect the window and seal in the full open and closed positions.
6. Open the sunroof.
7. Inspect the seal for high spots, correct if needed.