Instrument Panel (IP) - Accessory Trim Plate Replacement
TRIM PLATE REPLACEMENT - INSTRUMENT PANEL (I/P) ACCESSORYREMOVAL PROCEDURE
1. Remove the left instrument panel sound insulator.
2. Remove the knee bolster trim panel.
3. Remove the screws that retain the instrument panel accessory trim plate to the instrument panel.
4. Remove the instrument panel accessory trim plate by releasing the retaining clips.
5. Position the instrument panel accessory trim plate in order to remove the control switches.
- Remove the selectable 4WD switch, if equipped.
- Remove the inflatable restraint IP module switch.
- Remove the headlamp switch.
INSTALLATION PROCEDURE
1. Position the instrument panel accessory trim plate in order to install the control switches.
- Install the selectable 4WD switch, if equipped.
- Install the inflatable restraint IP module switch.
- Install the headlamp switch.
2. Install the instrument panel accessory trim plate clips to the instrument panel.
3. Install the screws that retain the instrument panel accessory trim plate to the instrument panel.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 1.9 N.m (17 lb in).
4. Install the knee bolster trim panel.
5. Install the left instrument panel sound insulator.