Ignition Lock Cylinder Case

Removal Procedure

Caution: Refer to SIR Caution.

1. Disable the SIR system.
2. Remove the ignition switch. Ignition Switch
3. Remove the turn signal cancel cam.
4. Remove the park lock cable from the lock cylinder housing.






5. Remove 3 TORX screws.
6. Remove the lock cylinder housing from the steering column.

Installation Procedure

Notice: Refer to Fastener Notice.






1. Install 3 TORX screws into the lock cylinder housing. Tighten the TORX screws to 7 Nm (62 in. lbs.)
2. Install the turn signal cancel cam.
3. Install the park lock cable into the lock cylinder housing.
4. Install the ignition switch. Ignition Switch
5. Enable the SIR system.