Tire Hoist and Shaft Replacement
Tire Hoist and Shaft ReplacementRemoval Procedure
1. Remove the spare tire from the tire carrier.
2. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
3. Remove the hoist mounting nuts.
4. Remove the hoist mounting bolts.
5. Remove the pin and the retainer.
6. Remove the hoist from the rear crossmember.
Installation Procedure
1. Install the hoist to the rear crossmember. Align the hoist with the rear crossmember and the shaft.
2. Install the pin and the retainer.
3. Install the hoist mounting bolts.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the hoist mounting nuts.
Tighten the hoist mounting nuts to 26 Nm (19 ft. lbs.).
5. Lower the vehicle.
6. Install the spare tire to the carrier.