Control Lever and/or Boot Replacement
Control Lever and/or Boot ReplacementRemoval Procedure
1. If equipped remove the 3 console nuts and the console.
2. Remove the shift lever from the shift tower. Do not remove the shift lever adjusting nut.
3. Pull back the carpet to access the screws.
4. Remove the screws securing the boot to the panel.
Installation Procedure
1. Install the boot over the shift tower.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the shift boot screws.
^ Tighten the screws to 2 Nm (18 inch lbs.).
3. Install the shift lever to the shift tower. If required, center the shift lever with the adjusting nut.
^ Tighten the adjusting nut to 48 Nm (35 ft. lbs.).
4. If equipped Install the console and the 3 console nuts.
^ Tighten the nuts to 2 Nm (18 inch lbs.).