Accessory

Drive Belt Replacement - Accessory

Removal Procedure

1. Remove the air cleaner assembly.





2. Remove the retaining bolt for the coolant recovery reservoir and set the reservoir aside.





3. Install a breaker bar with hex-head socket to the drive belt tensioner bolt.
4. Rotate the drive belt tensioner clockwise in order to relieve tension on the belt.
5. Remove the belt from the pulleys and the drive belt tensioner.
6. Slowly release the tension on the drive belt tensioner.
7. Remove the breaker bar and socket and from the drive belt tensioner bolt.
8. Clean and inspect the belt surfaces of all the pulleys.

Installation Procedure





1. Route the drive belt around all the pulleys except the idler pulley.
2. Install the breaker bar with hex-head socket to the belt tensioner bolt.
3. Rotate the belt tensioner clockwise in order to relieve the tension on the tensioner.
4. Install the drive belt under the idler pulley.
5. Slowly release the tension on the belt tensioner.
6. Remove the breaker bar and socket from the belt tensioner bolt.
7. Inspect the drive belt for proper installation and alignment.

Notice: Refer to Fastener Notice in Service Precautions.

8. Position the coolant recovery reservoir and install the retaining bolt.
^ Tighten the bolt to 11 Nm (97 inch lbs.).
9. Install the air cleaner assembly.