Ignition Switch

Ignition Switch Replacement- On Vehicle

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the SIR system.
2. Remove the steering column trim covers from the steering column.
3. Disconnect the steering column electrical connectors.





4. Remove the steering column wiring harness tie straps.





5. Remove the steering column wire harness (1) from the steering column and the wire harness strap (2).
6. Remove and dispose of the small wire harness straps from the wire harness assembly (1).





7. Disconnect the multifunction switch electrical connectors (2) from the bulkhead connector (1).





8. Remove the key alarm connector (1) from the lock module assembly (2) in the following way:
8.1. Rotate the key alarm connector (1) 90°.
8.2. Pull the key alarm connector (1) out of the lock module assembly (2).
8.3. Remove the passkey connector from the lock module assembly (2).





9. Slide the ignition and key alarm switch assembly (2) out of the lock module assembly (1).

Installation Procedure





1. Slide the ignition and key alarm switch assembly (2) into the lock module assembly (1).





2. Install the key alarm connector (1) into the lock module assembly (2).
2.1. Push the key alarm connector (1) into the lock module assembly (2).
2.2. Rotate the key alarm connector (1) 90° so that the key alarm connector (1) locks into place.
2.3. Install the passkey connector into the lock module assembly (2).





3. Connect the multifunction switch electrical connectors to the bulkhead connector (1).





4. Install the wire harness assembly (1) to the wire harness strap (2).





5. Attach new wire harness straps to the wire harness assembly (1).





6. Connect the steering column electrical connectors to the vehicle.
7. Install the trim covers to the column.
8. Enable the SIR system.