Armrest Replacement - Rear Seat with RPO YC5, YC6
ARMREST REPLACEMENT - REAR SEAT WITH RPO CODES YC5 AND YC6REMOVAL PROCEDURE
1. Remove the rear bench seat from the vehicle.
2. Fold down the seat back.
3. Remove the upper and lower seat back latch and seat back hinge trim.
4. Unzip the seat back cover.
5. Reach inside the seat back and remove the armrest retaining clip from the stud.
6. Remove the armrest from the seat back.
7. Remove the armrest cover for cleaning or replacement, if needed:
7.1. Unzip the cover.
7.2. Slide the cover off the armrest.
INSTALLATION PROCEDURE
1. Install the armrest cover to the armrest, if you removed the cover.
2. Install the armrest from the seat back.
3. Reach inside the seat back and install the armrest retaining clip.
- Install the clip with the opening facing down.
- Observe the fit of the clip once installed. If the clip is loose when fitted in the groove in the seat back frame, remove the clip and crimp the clip closed slightly.
Repeat this procedure until the clip fits snugly in the groove, or install a new clip.
4. Zip the seat back cover.
5. Install the upper and lower seat back latch and seat back hinge trim.
6. Fold up the seat back.
7. Install the rear bench seat to the Vehicle.