Evaporator Tube Replacement (With RPO Code C60)

EVAPORATOR TUBE REPLACEMENT (WITH RPO CODE C60)

TOOLS REQUIRED
J 39400-A Halogen Leak Detector

REMOVAL PROCEDURE
1. Remove the air cleaner.
2. Recover the refrigerant from the system.




3. Loosen the evaporator tube nut at the evaporator.
4. Remove the evaporator tube (2) from the evaporator.
5. Remove the O-ring seal.
6. Remove the grille.
7. Loosen the evaporator tube nut at the condenser.
8. Remove the evaporator tube (2) from the condenser (4).
9. Remove the O-ring seal.

INSTALLATION PROCEDURE




1. Install the new O-ring seal.
2. Install the evaporator tube (2) to the condenser (4).
3. Tighten the evaporator tube nut (3) to the condenser (4).

NOTE: Refer to Fastener Notice in Service Precautions.


Tighten
Tighten the nut to 28 N.m (20 lb ft).

4. Install the grille.
5. Install the new O-ring seal.
6. Install the evaporator tube to the evaporator.
7. Tighten the evaporator tube nut at the evaporator.

Tighten
Tighten the nut to 28 N.m (20 lb ft).

8. Evacuate and recharge the system.
9. Leak test the fittings of the component using the J 39400-A.
10. Install the air cleaner.