Transfer Case Fluid Replacement

Transfer Case Fluid Replacement

Removal Procedure

Important: When servicing the transfer case, use only hand tools when removing the transfer case fill or drain plugs.





1. Raise the vehicle.
2. Remove the transfer case shield.

Important: If the transfer case drain or fill plugs are damaged and need to be replaced, use only replacement plugs that are made from aluminum.

3. Remove the transfer case fill plug.






Important: When draining the transfer case oil, always the proper container for draining.

4. Remove the transfer case drain plug.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the transfer case drain plug.
^ Tighten the transfer case drain plug to 20 Nm (15 ft. lbs.)






Important: When filling the transfer case with the approved fluid level, the transfer case fluid should be level with treads for the fill hole.

2. Fill the transfer case with the proper amount and type of transfer case fluid.
3. Install the transfer case fill plug.
^ Tighten the transfer case fill plug to 20 Nm (15 ft. lbs.).
4. Install the transfer case shield.
5. Lower the vehicle.