Parking/Turn Signal Lamp Replacement (Base)

Parking and Turn Signal Lamp Replacement (Base)

Removal Procedure





1. Remove the screws (3) from the park/turn signal lamp to the grille.
2. Remove the park/turn signal lamp (2) from the grille.
3. Disconnect the bulb socket (1) from the park/turn signal lamp by turning the bulb sockets in a counterclockwise direction.
4. Remove the bulb (1) from the socket.

Installation Procedure

1. Install the bulb (1) into the socket by turning the bulb sockets in a clockwise direction.
2. Connect the bulb socket (1) into the park/turn signal lamp.
3. Install the park/turn signal lamp (2) to the grille (5).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the park/turn signal lamp retaining screws (3) to the grille.

Tighten
Tighten the screws to 1.5 Nm (13 lb in).