P0068

DTC P0068

CIRCUIT DESCRIPTION
The powertrain control module (PCM) uses the following readings to calculate the predicted mass air flow (MAF) rate:
- The throttle position (TP)
- The barometric pressure (BARO)
- The intake air temperature (IAT)
- The engine RPM

The PCM compares the predicted MAF value to the actual MAF value, and to the speed density calculation, in order to verify the proper throttle operation.

CONDITIONS FOR RUNNING THE DTC
- DTCs P0601, P0602, P0604, P0606, P1516, P2101, P2108, U0107 are not set.
- DTCs P0120 and P0220 are not active at the same time.
- The engine operates longer than 1 second.
- The engine speed is more than 500 RPM.

CONDITIONS FOR SETTING THE DTC
- The PCM detects that the difference between the actual air flow and the speed density calculated air flow is more than expected.
- The above condition is met for less than 1 second.

ACTION TAKEN WHEN THE DTC SETS
- The control module illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.
- The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Freeze Frame and/or the Failure Records.
- The control module commands the TAC system to operate in the Reduced Engine Power mode.
- A message center or an indicator displays Reduced Engine Power.
- Under certain conditions the control module commands the engine OFF.

CONDITIONS FOR CLEARING THE MIL/DTC
- The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
- A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
- Clear the MIL and the DTC with a scan tool.

DIAGNOSTIC AIDS
- Inspect the throttle blade for being broken, bent, or missing.
- Inspect the TP sensor for proper installation. A sensor that is mis-aligned could set this DTC.
- Inspect the throttle actuator control (TAC) module connectors for signs of water intrusion. If water intrusion occurs, multiple DTCs may set without any circuit or component conditions found during diagnostic testing.
- Physically and visually inspect the throttle body assembly and correct any problems that you observe. Manually move the throttle blade from closed to wide open throttle (WOT). You should not need to use excess force. The throttle blade should move smoothly through the full range, then should independently return to a slightly open position.
- When the TAC module detects a condition within the TAC system, more than one TAC system related DTC may set. This is due to the many redundant tests run continuously on this system. Locating and repairing one individual condition may correct more than one DTC. Disconnecting components during testing may set additional DTCs. Remember this if you review the stored information in Capture Info.
- For an intermittent condition, refer to Intermittent Conditions. Diagnostic Strategies

TEST DESCRIPTION

Steps 1 - 2:

Steps 3 - 5:

Steps 6 - 7:

Steps 8 - 9:

The numbers below refer to the step numbers on the diagnostic table.
5. This step will determine if the manifold absolute pressure (MAP) sensor voltage is within the proper range at idle.
6. This step will determine if the MAP sensor responds properly to the change in manifold pressure.
7. A throttle blade that sticks or binds may set this code. Opening the throttle through the entire range will indicate problems such as these.
9. When the PCM detects a condition within the ETC system other DTCs may set due to the many redundant tests run continuously on this system. Locating and repairing one individual condition may correct more than one DTC. Keep this in mind when reviewing captured DTC info.