Hinged Side Window Replacement

Hinged Body Side Window Replacement

Tools Required
* J 39032 Stationary Glass Removal Tool
* Urethane Adhesive Kit GM P/N 12346392 or Equivalent
* Isopropyl Alcohol or Equivalent
* Cartridge-type Caulking Gun
* Commercial-type Utility Knife
* Razor Blade Scraper
* Suction Cups
* Plastic Paddle

Removal Procedure

Caution: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and interior trim.

1. Open the side access door.
2. Cover to protect the following parts from broken glass if necessary:

1. Upper dash pad.
2. Defroster outlets and A/C outlets.
3. Seats and carpeting.

3. Remove the side access door trim, if equipped.






Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.

Important: Keep the cutting edge of the tool against the hinged body side window frame. Do this from inside the vehicle.

4. This will allow the urethane adhesive to be separated from the hinged body side window frame.

* Leave a base of urethane on the pinchweld flange.
* The only suitable lubrication is clear water.
* Use J 39032 or equivalent in order to remove the hinged body side window.

5. If the original hinged body side window frame is damaged it must be replaced, if equipped.




6. With the aid of an assistant, remove the window from the opening.

Installation Procedure

1. Install a stationary window into the opening.
2. Install the side access door trim, if equipped.
3. Remove the double layer of masking tape around the perimeter of the painted surfaces and interior trim.
4. Close the side access door.