8. Crankshaft Balancer Removal

Crankshaft Balancer Removal

^ Tools Required
- J 23523-F Balancer Remover and Installer





1. Remove the crankshaft balancer bolt and washer.





2. Remove the bolts and the crankshaft pulley.






3. Use the J 23523-F in order to remove the crankshaft balancer.

Notice:
Refer to Fastener Notice in Service Precautions.

1. Install the J 23523-F plate and bolts onto the crankshaft balancer.
^ Tighten the bolts to 25 Nm (18 lb ft).
2. Install the J 23523-F forcing screw into the plate.
3. Rotate the J 23523-F forcing screw clockwise in order to remove the crankshaft balancer.
4. Remove the J 23523-F from the crankshaft balancer.






5. Note the position and length of any crankshaft balancer front groove pins, if applicable.

Important:
If replacing the crankshaft balancer, NEW weights must be installed into the NEW crankshaft balancer, in the same location as the old weights in the old balancer.