Heater Hose Replacement - Inlet

HEATER HOSE REPLACEMENT - INLET

TOOLS REQUIRED
J 43181 Quick Connect Connector Removal Tool

REMOVAL PROCEDURE
1. Drain the cooling system. Refer to Draining and Filling Cooling System (with HP2)Draining and Filling Cooling System (without HP2) in Cooling System.
2. Remove the air intake tube.
3. Remove the heater and surge tank hose from the mounting clip.




4. Using the J 43181 disconnect the heater hose from the heater core inlet.
4.1. Install the J 43181 to the heater core pipe.
4.2. Close the tool around the heater core pipe.
4.3. Firmly pull the tool into the quick connect end of the heater hose.
4.4. Firmly grasp the heater hose. Pull the heater hose forward in order to disengage the hose from the heater core.




5. Remove the inlet heater hose from the engine.




6. Remove the inlet heater hose.

INSTALLATION PROCEDURE




1. Install the inlet heater hose.




2. Install the inlet heater hose to the engine.
3. Connect the heater and surge tank hose to the heater core.
Firmly push the quick connect onto the heater core pipe until you hear an audible click.
4. Install the heater and surge tank hose to the mounting clip.
5. Install the air intake tube.
6. Fill the cooling system. Refer to Draining and Filling Cooling System (with HP2)Draining and Filling Cooling System (without HP2) in Cooling System.