4. Clutch Pilot Bearing Removal

Clutch Pilot Bearing Removal (without RPO HP2)

^ Tools Required
- J 43276 Clutch Pilot Bearing Remover






1. Notice:
When using the J 43276 Clutch Pilot Bearing Remover, always secure the J 43276-1 Clutch Pilot Bearing Remover tool body using a wrench. Do not allow the J 43276-1 tool body to rotate. Failing to do so causes damage to the J 43276-1 tool body.

Important:
The flywheel spacer, if applicable, must be removed prior to clutch pilot bearing removal.
Remove the clutch pilot bearing using the J 43276.

1. Install the J 43276-1 into the clutch pilot bearing.
2. Using a wrench, secure the J 43276-1.
3. Insert the J 43276-2 into the J 43276-1.
4. Rotate the J 43276-2 clockwise into the J 43276-1 until the clutch pilot bearing is completely removed from the crankshaft.
5. Rotate the J 43276-2 counterclockwise to remove the J 43276-2 from the J 43276-1.
6. Remove the J 43276-1 from the tool body.





8. Discard the pilot bearing.