Input Shaft Disassemble

Input Shaft Disassemble

^ Tools Required
- J 22912-01 Split Plate Bearing Puller





1. Install the J22912-01 (1) under the input shaft bearing.
2. Remove input shaft bearing cone using the J 22912-01 (1) and a hydraulic press.





Important:
^ The input shaft bearing race is not serviceable. If the race is faulty, replace the input shaft bearing retainer.
^ Replace both the input shaft bearing and the input shaft bearing retainer, if either is faulty.

3. Remove the seal from the input shaft bearing retainer.
4. Discard the seal.