Fuel Injector Control Module (FICM) to Fuel Feed Pipe
FUEL HOSE REPLACEMENT - FUEL INJECTOR CONTROL MODULE (FICM) TO FUEL FEED PIPEREMOVAL PROCEDURE
1. Drain the cooling system.
2. Disconnect the negative battery cable.
3. Remove the air cleaner outlet duct.
4. Remove the engine wiring harness.
5. Remove the fuel feed front connector pipe bolt from the fuel injector control module (FICM).
6. Reposition the fuel feed hose clamps.
7. Remove the fuel hose (1) from fuel feed front connector pipe.
8. Remove the fuel hose (1) from fuel feed front pipe.
INSTALLATION PROCEDURE
IMPORTANT: Always install new fuel line gaskets when servicing the fuel lines.
1. Install the fuel hose (1) to fuel feed front pipe.
2. Install the fuel hose (1) to fuel feed front connector pipe.
3. Reposition the fuel feed hose clamps.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the fuel feed front connector pipe bolt to the FICM.
Tighten
Tighten the bolt to 12 N.m (106 lb in).
5. Install the engine wiring harness.
6. Install the air cleaner outlet duct.
7. Connect the negative battery cable
8. Fill the cooling system.