87. Output Shaft Bushing Inspection

Output Shaft Bushing Inspection - 2WD





1. Inspect output shaft bushing (2) for wear and damage.
2. Measure the ID of bushing (2) at dimension A. Replace the bushing if the Inside Diameter (ID) of the bushing exceeds specification.

Maximum ID is 20.070 mm (0.7940 inch).
3. Measure the Outside Diameter (OD) of the bearing surface at dimension B. Replace the output shaft If the OD of the bearing surface exceeds specification.

Bearing Surface OD
Minimum OD is 44.978 mm (1.7708 inch)