Transmission Output Shaft Seal Replacement

Transmission Output Shaft Seal Replacement

^ Tools Required
- J 6125-1B Slide Hammer
- J 44732 Output Shaft Oil Seal Installer
- J 23129 Universal Seal Remover
- J 8614-01 Pinion Flange Holder

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the rear propeller shaft.
3. Using the J 8614-01 to hold the transmission yoke, remove and discard the yoke nut.





4. Remove the yoke.





5. Using J 6125-1B (1) and J 23129 (2), remove the rear oil seal.

Installation Procedure

Important: The J 44732 will set the oil seal to the proper depth. Failure to use the J 44732 will cause improper installation of the oil seal.





1. Using J 44732 install the rear oil seal.





2. Install the yoke.
3. Use the J 8614-01 in order to hold the yoke.

Notice: Refer to Fastener Notice in Service Precautions..

4. Install a NEW yoke nut.
^ Tighten the nut to 330 Nm (244 ft. lbs.).

5. Install the rear propeller shaft.
6. Check the transmission fluid level. Add if necessary.
7. Lower the vehicle.