California Emissions and With RPO Code VCL
DTC P0301 (CALIFORNIA EMISSIONS, AND WITH RPO CODE VCL)CIRCUIT DESCRIPTION
The engine control module (ECM) monitors changes in crankshaft speed using inputs from the crankshaft position (CKP) sensor and the fuel injection control module (FICM). The ECM adjusts the fuel delivery to each cylinder in order to minimize crankshaft speed changes. This DTC will set when the ECM identifies a cylinder or cylinders requiring an excessive amount of fuel in order to maintain the correct crankshaft speed.
CONDITIONS FOR RUNNING THE DTC
- The engine is running at idle for more than 30 seconds.
- The engine coolant temperature (ECT) is more than 56°C (132°F).
CONDITIONS FOR SETTING THE DTC
The fuel rate adjustment for a cylinder exceeds an acceptable value.
ACTION TAKEN WHEN THE DTC SETS
- The control module illuminates the malfunction indicator lamp (MIL) on the second consecutive ignition cycle that the diagnostic runs and fails.
- The control module records the operating conditions at the time the diagnostic fails. The first time the diagnostic fails, the control module stores this information in the Failure Records. If the diagnostic reports a failure on the second consecutive ignition cycle, the control module records the operating conditions at the time of the failure. the control module writes the operating conditions to the Freeze Frame and updates the Failure Records.
CONDITIONS FOR CLEARING THE MIL/DTC
- The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
- A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
- Use a scan tool in order to clear the MIL and the DTC.
DIAGNOSTIC AIDS
A misfire with no other DTC's will be caused by an engine mechanical or fuel injector problem.
TEST
