120. Glow Plug Controller and Glow Plugs Installation

Glow Plug Controller and Glow Plugs Installation






1. Notice:
Refer to Fastener Notice in Service Precautions.

Install the glow plugs to the right cylinder bank.
^ Tighten the glow plugs to 18 Nm (13 ft. lbs.).
2. Install the glow plug harness to the right cylinder bank (1 California, 2 Federal).





3. Install the glow plug power feed wire to the right cylinder bank.
4. Install the glow plug harness nuts to the right cylinder bank.
^ Tighten the glow plug harness nuts to 2 Nm (18 inch lbs.).
5. Install the glow plugs to the left cylinder bank.
^ Tighten the glow plugs to 18 Nm (13 ft. lbs.).
6. Install the glow plug harness to the left cylinder bank (1 California, 2 Federal).



7. Install the glow plug controller.
8. Install the glow plug controller nuts.
^ Tighten the glow plug controller nuts to 25 Nm (18 ft. lbs.).
9. Install the glow plug power feed wire to the left cylinder bank.
10. Install the glow plug harness nuts to the left cylinder bank.
^ Tighten the glow plug harness nuts to 2 Nm (18 inch lbs.).
11. Install the glow plug harness bracket bolt.
^ Tighten the glow plug harness bracket bolt to 21 Nm (15 ft. lbs.).





12. Install the intake air heater connector.