Boost Sensor Replacement (Federal Emissions)

BOOST SENSOR REPLACEMENT (FEDERAL EMISSIONS)

REMOVAL PROCEDURE




1. Remove the air cleaner outlet duct.
2. Disconnect the boost sensor electrical connector (2).
3. Remove the boost sensor bracket nut (4).
4. Lift the coolant tube (1) off of the stud and move it out of the way.




5. Remove the boost sensor (2) with bracket (1).
6. Remove the sensor from the bracket.
7. Inspect the boost sensor seal for damage, replace as necessary.

INSTALLATION PROCEDURE




1. Position the sensor (2) onto the bracket (1).
2. Install the bracket (with sensor) over the stud.




3. Position the coolant tube (1) over the stud.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the boost sensor bracket nut (4).

Tighten
Tighten the nut to 9 N.m (80 lb in).

5. Connect the boost sensor electrical connector (2).
6. Install the air cleaner outlet duct.