Pedal Positioning Switch: Service and Repair

Brake Pedal Position Sensor Replacement

Removal Procedure





1. Important:
Once the Brake Pedal Position Sensor bolt is removed for any reason, a new 4 mm bolt, with fresh LOCTITETM will need to be installed.
Remove the brake pedal position sensor bolt (1).





2. Remove the brake pedal position sensor (2) from the mounting bracket.
3. Disconnect the brake pedal position sensor electrical connector (1).
4. Remove the brake pedal position sensor (2) from the vehicle

Installation Procedure





1. Connect the brake pedal position sensor (2) electrical connector (1).





2. Align the brake pedal position sensor (1) with the actuation arm (2) on the brake pedal and the brake pedal position sensor mounting bracket.





3. Notice:
Refer to Fastener Notice in Service Precautions.
Install a new 4 mm bolt (1), with LOCTITETM , to the brake pedal position sensor.
^ Tighten the bolt to 9 Nm (80 inch lbs.).
4. Calibrate the brake pedal position sensor.