Seat Adjuster Replacement - Front (Power W/ Motor Assembly)

Seat Adjuster Replacement - Front (Power w/ Motor Assembly)

Removal Procedure

1. Adjust the seat to the full upward front and rear position.
2. Remove the seat from the vehicle.
3. Remove the power seat switch from the seat.




4. Remove the seat belt buckle from the seat.




5. Separate the J-strips from the seat bottom frame.
6. Pull the seat cover and pad up to expose the seat bottom frame.
7. Disconnect the electrical connectors as necessary.
8. Remove the bolts securing the seat back assembly to the seat adjuster assembly.
9. Remove the seat back assembly.




10. Remove the 4 nuts securing the seat bottom frame to the seat adjuster assembly.
11. Remove the seat adjuster assembly.


Installation Procedure






Notice: Refer to Fastener Notice in Service Precautions.

1. Install the seat adjuster assembly to the seat bottom frame with 4 nuts.

Tighten the adjuster to the seat bolts to 24 N.m (18 lb ft).

2. Install the seat back assembly to the seat adjuster assembly with four bolts.

Tighten the bolts to 24 N.m (18 lb ft).

3. Connect the electrical connectors.
4. Pull the seat pad and seat cover back down on the seat bottom frame.




5. Engage the J-strips to the seat bottom frame.




6. Install the seat belt buckle to the seat.

Tighten the seat belt buckle bolt to 70 N.m (52 lb ft).

7. Install the power seat switch to the seat.
8. Install the seat to the vehicle.
9. If the vehicle is equipped with memory seats, calibrate the seat. Refer to Memory Seat Calibration Procedure.