Dome Lamp: Service and Repair

DOME LAMP REPLACEMENT

REMOVAL PROCEDURE
On pickup models, the dome lamp is located on the roof panel above the rear glass.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the battery negative cable.




2. Squeeze the dome lamp lens in order to remove the lens.
3. Remove the dome lamp bulb.
4. Remove the screws that retain the dome lamp base to the center high mount stoplamp from inside the vehicle.
5. Remove the dome lamp base from the vehicle.

INSTALLATION PROCEDURE




1. Install the dome lamp base to the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the screws that retain the dome lamp base to the high mount stoplamp from inside of the vehicle.

Tighten
Tighten the screws to 2.5 N.m (22 lb in).

3. Install the dome lamp bulb.
4. Install the dome lamp lens.
Squeeze the lens in order to engage the tabs.
5. Install the battery negative cable.