Fog Lamp Replacement - Rear
FOG LAMP REPLACEMENT - REARREMOVAL PROCEDURE
1. Ensure that the headlamp switch is in the OFF position.
2. Ensure that the ignition switch is in the LOCK position.
3. Open the endgate or liftgate.
4. Remove the screws that retain the tail lamp assembly to the vehicle.
5. Rotate the fog lamp bulb socket 1/4 turn counterclockwise in order to remove the bulb socket from the tail lamp assembly.
6. Remove the bulb from the socket.
INSTALLATION PROCEDURE
1. Install the bulb to the socket.
2. Install the bulb socket to the tail lamp assembly by rotating the socket 1/4 turn clockwise.
3. Install the tail lamp assembly to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the screws that retain the taillamp assembly to the vehicle.
Tighten
Tighten the screws to 1.9 N.m (17 lb in).
5. Close the endgate or liftgate.