Ignition Lock Cylinder

Ignition Lock Cylinder Replacement - On Vehicle

Removal Procedure

Caution: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the battery negative cable.

Caution: Refer to SIR Caution in Service Precautions.

2. Disable the SIR system.
3. Remove the steering column trim covers.
4. Turn the ignition lock cylinder to the start position.





5. Using an awl, insert the tip into the ignition lock cylinder access hole (1).
6. Push down and hold the ignition lock cylinder retaining pin.
7. Release the ignition lock cylinder to the run position.





8. Remove the ignition lock cylinder by pulling the ignition lock cylinder away from the steering column.

Installation Procedure





1. Install the ignition lock cylinder by doing the following procedure:
1.1. Align the positioning locking tab slot on the lock module to the positioning tab on the ignition lock cylinder.
1.2. Push the lock cylinder in until the locking tab locks in the lock module.
2. Install the steering column trim covers.
3. Enable the SIR system.
4. Connect the battery negative cable.
5. Perform the PASSLOCK learn procedure.