Rear Wheel Steering Control Module Replacement
Rear Wheel Steering Control Module ReplacementRemoval Procedure
1. Raise the vehicle.
2. Disconnect the electrical connector from the control module.
3. Remove the nuts retaining the control module (2) to the bracket.
4. Remove the control module from the bracket (4).
Installation Procedure
1. Install the control module (2) to the bracket.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the nuts retaining the control module to the vehicle.
^ Tighten the control module retaining nuts to 25 Nm (18 ft. lbs.).
3. Connect the electrical connectors to the control module.
4. Program the control module.
5. Perform a learn alignment.