Operation CHARM: Car repair manuals for everyone.
Home >> GMC Truck >> 2004 >> Yukon/Denali 2WD V8-5.3L VIN T >> Repair and Diagnosis >> Heating and Air Conditioning >> Compressor HVAC >> Service and Repair >> Compressor Replacement

Compressor Replacement

COMPRESSOR REPLACEMENT

TOOLS REQUIRED
J 39400-A Halogen Leak Detector

REMOVAL PROCEDURE




1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
2. Install a ratchet into the air conditioning (A/C) belt tensioner adapter opening.
3. Rotate the A/C belt tensioner clockwise in order to relieve the tension on the belt.
4. Remove the A/C belt from the A/C compressor.
5. Slowly release the tension on the A/C belt tensioner.
6. Remove the right front tire and wheel assembly.
7. Remove the wheel house panel from the vehicle.
8. Remove the discharge hose bolt from the A/C compressor.
9. Remove the discharge hose from the A/C compressor.
10. Remove the suction hose bolt from the A/C compressor.
11. Remove the suction hose from the A/C compressor.
12. Discard the sealing washers. Cap all of the openings.
13. Disconnect the electrical connections.




14. Remove the A/C compressor mounting bolts. The lower right bolt (3) will stay with the compressor due to a lack of clearance.
15. Remove the A/C compressor (2) from the bracket (1).
16. If replacing the A/C compressor. Refer to Compressor Oil Balancing.

INSTALLATION PROCEDURE




1. Install the A/C compressor (2) to the bracket (1) through the fender well. Insert the mounting bolt (3) into the lower right mounting boss before installing the A/C compressor.
2. Install the A/C compressor to the bracket. Insert the mounting bolt into the lower right mount before installing the A/C compressor.
3. Install the A/C compressor mounting bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolts to 50 N.m (37 lb ft).

4. Connect the electrical connector to the A/C compressor.
5. Install the A/C discharge hose to the compressor using new sealing washers.
6. Install the A/C discharge hose bolt to the A/C compressor.

Tighten the bolt to 16 N.m (12 lb ft).

7. Install the A/C suction hose to the compressor using new sealing washers.
8. Install the A/C suction hose bolt to the A/C compressor.

Tighten the bolt to 16 N.m (12 lb ft).

9. Install the wheel house panel to the vehicle.
10. Install the right front tire and wheel assembly.
11. Install the A/C drive belt.
12. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
13. Leak test the fittings of the component using the J 39400-A.

pro multis · About Operation CHARM