Headlamp Assembly or Headlamp Bulb Replacement (HID)

HEADLAMP ASSEMBLY OR HEADLAMP BULB REPLACEMENT (HID)

REMOVAL PROCEDURE

CAUTION: The high intensity discharge system produces high voltage and current. To reduce the risk of severe shocks and burns:
- Never open the high intensity discharge system ballast or the arc tube assembly starter.
- Never probe between the high intensity discharge system ballast output connector and the arc tube assembly.

NOTE: When removing or replacing the arc tube, the arc tube must not contact the side of the headlamp housing or the bulb shield. Damage to the arc tube may result.

1. Remove the front grille.




2. Remove the headlamp retainer pins.
3. Pull out the headlamp assembly in order to access the electrical connector.




4. Disconnect the electrical connector.
5. Remove the rubber cups to gain access to the headlamp bulbs.
6. Remove the bulbs.

INSTALLATION PROCEDURE
1. Install the bulbs.
2. Install the rubber cups.




3. Connect the electrical connector to the lamp assembly.




4. Install the lamp assembly to the vehicle.
5. Install the headlamp assembly retainer pins.
6. Install the front grille.