Mode Door - Upper (Visteon)

MODE DOOR REPLACEMENT - UPPER (VISTEON)

REMOVAL PROCEDURE
1. Remove the HVAC module assembly. Service and Repair




2. Disconnect the electrical connector (3) from the mode actuator (4).
3. Remove the screws from the mode actuator (4).
4. Remove the mode actuator (4) from the HVAC module assembly (1).
5. Remove the wiring harness from the air distribution housing (1).




6. Remove the screws from the air distribution housing (1).
7. Remove the air distribution housing (1) from the HVAC module assembly (2).




8. Remove the screws from the air distribution housing (1).
9. Separate the air distribution housing halves.




10. Remove the lever from the upper mode door (4).
11. Remove the lever from the defrost door (2).
12. Remove the door assembly (3) from the left air distribution housing (1).
13. Remove the mode door (4) from the door assembly (3).

INSTALLATION PROCEDURE




1. Install the mode door (4) to the door assembly (3).
2. Install the door assembly (3) to the left air distribution housing (1).
3. Install the lever to the defrost door (2).
4. Install the lever to the upper mode door (4).




5. Install the air distribution housing halves.
6. Install the screws to the air distribution housing (1).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 2 N.m (18 lb in).




7. Install the air distribution housing (1) to the HVAC module assembly (2).
8. Install the screws to the air distribution housing (1).

Tighten the screws to 2 N.m (18 lb in).

9. Install the wiring harness to the air distribution housing (1).




10. Connect the electrical connector (3) to the mode actuator (4).
11. Install the mode actuator (4) to the HVAC module assembly (1).
12. Install the screws to the mode actuator (4).

Tighten the screws to 2 N.m (18 lb in).

13. Install the HVAC module assembly.