Door Lock Switch Replacement

MIRROR, WINDOW, AND DOOR LOCK SWITCH REPLACEMENT

REMOVAL PROCEDURE




1. Remove the 2 screws securing the switch plate assembly to the door trim panel.
2. Lift the front of the switch plate up to disengage clip.
3. Remove the switch plate out of the door trim panel opening.




4. Disconnect the electrical connectors (3, 4) from the switches (2, 5).
5. Remove the switch plate assembly (1) from the vehicle.
6. If replacing only the switches, remove the switches from the plate.
7. If replacing only the switch plate, retain the switches for transfer.

INSTALLATION PROCEDURE




1. Install the switches (2, 5) to the switch plate (1).
2. Connect the electrical connectors (3, 4) to the switches (2, 5).




3. Install the switch plate assembly to the door trim panel with the 2 screws.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Tighten the front door switch plate screws to 2 Nm (18 lb in).