Power Door Lock Switch Replacement - Rear

POWER DOOR LOCK SWITCH REPLACEMENT - REAR

REMOVAL PROCEDURE




1. Remove the 2 screws securing the switch plate assembly to the door trim panel.
2. Lift the switch plate up and out of the door trim panel.




3. Disconnect the electrical connectors from the switch module.
4. Remove the switch plate assembly from the vehicle.
5. If replacing only the switch module, remove the module from the switch plate.
6. If replacing only the switch plate, retain the switch module for transfer.

INSTALLATION PROCEDURE




1. Install the switch module to the switch plate.
2. Connect the electrical connector to the switch module.




3. Install the rear switch plate assembly to the door trim panel with the 2 screws.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Tighten the rear door switch plate screws to 2 Nm (18 lb in).