Multifunction, Turn Signal Switch Housing

Multifunction Turn Signal Switch Housing Replacement

Removal Procedure

1. Caution: Refer to SIR Caution in Service Precautions.

Disable the SIR system.





2. Remove 2 washer head screws from the switch mounting plate. Slide the switch mounting plate from the steering column shaft.

Installation Procedure





1. Slide the switch mounting plate onto the steering column shaft.

2. Notice: Refer to Fastener Notice in Service Precautions.

Install 2 washer head screws into the switch mounting plate.
Tighten the screws to 2.5 Nm (22 inch lbs.).
3. Enable the SIR system.