Brake Light Switch: Service and Repair

STOP LAMP SWITCH REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the stop lamp switch electrical connector (1).




2. Rotate the switch (2) counterclockwise.
3. Remove the switch from the bracket (1).
4. Remove the switch from the vehicle.

INSTALLATION PROCEDURE




1. Position the switch (2) near the bracket.
2. Ensure the switch key-way is properly indexed to the plastic retainer (1).
3. Install the switch into the retainer and push forward ensuring tip of the switch is fully collapsed into the switch cavity.

IMPORTANT: Ensure the brake pedal is in a full back position and the tip of the stop lamp switch has contacted the brake pedal arm. Ensure the collapsing tip on the switch is fully retracted before rotation.

4. Turn the switch clockwise, locking the switch into the plastic retainer.
5. Ensure the switch is fully seated into the retainer.




6. Connect the stop lamp switch electrical connector (1).
7. Check the switch for proper operation.