Accessory Switch Transfer Case Mode Buttons Inoperative

Accessory Switch Transfer Case Mode Buttons Inoperative

Circuit Description
The accessory switch circuit consists of 4 modes. The transfer case shift control module supplies 5 volts to the switch through the switch signal circuit. The current travels through the resistor of the currently active mode. The current on the switch signal circuit is monitored by the transfer case shift control module. The voltage on the switch signal circuit will vary depending on which mode button is pressed by the driver.
The transfer case shift control module constantly monitors the switch signal circuit to determine the condition of the accessory switch circuit.
When each of the modes are selected they complete a circuit through their own specific resistor. The transfer case shift control module continuously monitors the switch signal circuit to determine whether the Neutral, 2HI, 4HI, or 4LO mode was selected by the driver.





Test Description
The numbers below refer to the step numbers on the diagnostic table.
2. This step tests the accessory switch for proper resistance values in all mode switch states.