Hood: Service and Repair

Hood Replacement

Removal Procedure

1. Remove the front hood molding.




2. Remove the push-pin retainers (2) from the hood and insulation.
3. Remove the insulation from the tabs (1) and remove the insulation from the hood.




4. Using a grease pencil or other suitable marking device, mark the position of the hood to the hinges (3).
5. Remove the 4 bolts that retain the hood hinges to the hood with an assistant.
6. Remove the hood from the vehicle with an assistant.

Installation Procedure




1. Position the hood to the vehicle with an assistant.
2. Partially install the 4 bolts that retain the hood to the hinges (3).

Notice: Refer to Fastener Notice in Service Precautions.

3. Position the hood to the hinges at the previously marked locations with an assistant.

Tighten the hood retaining bolts to 25 N.m (18 lb ft).




4. Install the hood insulation to the hood.
5. Install the push-pin retainers (2).
6. Install the front hood molding.