Module Rear Body Control Replacement - Endgate

MODULE REAR BODY CONTROL REPLACEMENT - ENDGATE

REMOVAL PROCEDURE
1. Remove the trim panel from the endgate.




2. Remove the screws (2) retaining the rear body control module (BCM) (1) to the endgate.
3. Disconnect the electrical connectors from the rear BCM.
4. Remove the module from the vehicle.

INSTALLATION PROCEDURE




1. Install the rear BCM (1) to the endgate.
2. Connect the electrical connectors to the module.
3. Install the screws (2) retaining the rear BCM to the endgate.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the rear BCM screws to 2.5 N.m (22 lb in).

4. Install the trim panel to the endgate.