Ignition Lock Cylinder

Ignition Lock Cylinder Replacement
Removal Procedure
1. Disconnect the negative battery cable.

2. Caution: Refer to Restraint Systems Caution in Service Precautions.

Disable the Restraint Systems. Refer to Restraint Systems Disabling and Enabling Zone 3 in Restraint Systems.
3. Lower the hush and knee bolster.
4. Remove the steering column trim covers.
5. With the key installed, turn the key to the RUN position.





6. Install an allen wrench into the hole on top of the lock cylinder housing. Push down on the allen wrench to release the tab on the lock cylinder inside the lock cylinder housing.





7. Slide the lock cylinder out of the lock cylinder housing.

Installation Procedure





1. Install the key into the lock cylinder.

2. Important: The gears between the ignition switch and the lock cylinder housing must be in the correct position. Failure to do so will cause a misalignment of the gears in the ignition switch and the lock cylinder housing, which may result in a NO START or BATTERY DRAIN.

Use a screwdriver to rotate the lock cylinder housing gear clockwise to the start position - allowing it to spring return into the RUN position.





3. Align the lock cylinder and install into the lock cylinder housing.
4. Install the steering column trim covers.
5. Install the hush and knee bolster.
6. Enable the Restraint Systems. Refer to Restraint Systems Disabling and Enabling Zone 3 in Restraint Systems.
7. Connect the negative battery cable.